EC480 Excavator Bucket Teeth Bulldozer Bucket Teeth 14553244

Product Description

Factory Direct excavator bucket Tooth EC480 Bulldozer bucket Tooth Tip Ripper India Excavator Bucket Teeth

For process analysis, take two samples from the front and rear working faces respectively, and grind them for hardness test. It is found that the hardness of the same sample varies greatly, and the preliminary judgment is that the material is uneven. The samples were ground, polished and corroded. It was found that there were obvious boundaries on each sample, but the boundaries were different. From the macro view, the surrounding is light gray, and the middle part is dark, which indicates that the part is likely to be an inlay casting. From the surface, the enclosed part should also be an inlay. Hardness tests were carried out on both sides of the boundary on HRS-150 digital Rockwell hardness tester and MHV-2000 digital micro hardness tester, and obvious differences were found (see Table 1). Through the above analysis, it is confirmed that the bucket tooth is an insert structure. The closed part is the insert, and the surrounding part is the base. The compositions of the two are similar. The alloying is carried out with Cr, Mn, Si and other elements. The main alloy compositions (mass fraction,%) are 0.38C, 0.91Cr, 0.83Mn, 0.92Si. The mechanical properties of metal materials depend on their composition and heat treatment process. The components are similar but the hardness is different, which indicates that the bucket teeth are put into use without heat treatment after casting. The following organizational observation also proves this point.

FAQ

Q1:Are you a trade or a manufacure?

A:We are an industry and trade integration business, our factory located on Quanzhou Nanan Distric.

Q2:How can I be sure the Excavator Sprocket will fit my excavator?

A:Give us correct model number/machine serial number/ any numbers on the parts itself.

Or measure the parts give us dimension or drawing.

Q3:How about the payment terms for Excavator Sprocket ?

A:We usually accept T/T or L/C. other terms also could be negotiated.

Q4:What is your minimum order for Excavator Sprocket ?

A:It depends on what you are buying. Normally, our minimum order is one 20’ full container

and LCL container (less than a container load) can be acceptable.

Q5:What is your delivery time for Excavator Sprocket ?

A:FOB Xiamen or any Chinese port : 25-30days . If there are any parts in stock ,

our delivery time is only 7-10 days.

Q6:What about Quality Control?

A:We have excellent tester, check every piece to ensure the quality is good,

and strict control to ensure product safety into container.